Red Ripper Ultralight Super Stone Router with Makita GA7040S Motor

The Red Ripper Ultralight Super Stone Router is a lightweight, direct-drive edge-shaping machine powered by a 2 HP Makita GA7040S motor. Designed for profiling sinks and countertop edges, it weighs only 22 pounds for easier handling in the fabrication shop.

A built-in hydroplaning base helps the router move smoothly across the stone surface without scratching. The router can be used on natural and engineered stone and accepts compatible stone-router bits with a standard 7/8-inch bore and M10-1.5 bolt.

Typical Applications

• Profiling sink openings
• Shaping countertop edges
• Working on prefabricated countertops
• Routing natural stone
• Routing engineered stone

Advantages

• Lightweight 22-pound design
• 2 HP direct-drive motor
• Built-in hydroplaning base
• Designed to move smoothly over stone without scratching
• Accepts compatible router bits with a standard 7/8-inch bore and M10-1.5 bolt
• Supports common 2 cm, 3 cm and 4 cm router bits
• Designed for natural and engineered stone
• 8,500 RPM at the bit under no-load conditions

Specifications

• Product type: Handheld stone router
• Drive type: Direct drive
• Motor: Makita GA7040S
• Motor power: 2 HP
• Weight: 22 pounds
• No-load speed at bit: 8,500 RPM
• Compatible bit bore: 7/8 inch
• Bit-mounting bolt: M10-1.5
• Common supported bit sizes: 2 cm, 3 cm and 4 cm
• Base type: Hydroplaning
• Primary function: Edge shaping and sink profiling
• Polishing application: No

Compatible Materials

• Natural stone
• Engineered stone

Included Components

• Red Ripper Ultralight base
• Spindle
• Water shield
• Makita GA7040S grinder
• Inline GFCI with 25-foot power cord
• Watertight quick-disconnect
• 10-foot quick-disconnect water hose

Operating Information

This router is intended for edge shaping and sink profiling, not polishing.

According to the supplied product information, almost all standard stone-router bits with a 7/8-inch bore and M10-1.5 mounting bolt can be used, including common 2 cm, 3 cm and 4 cm bits.

Tooling Note: Using larger bits may cause the machine to become unbalanced. Confirm bit compatibility and proper machine balance before operation.

Frequently Asked Questions

What is the Red Ripper Ultralight Super Stone Router used for?

It is designed for profiling sink openings and shaping countertop edges.

Can this router be used for polishing?

No. The supplied product information identifies it as an edge-shaping machine rather than a polishing machine.

What materials can it be used on?

It can be used on natural stone and engineered stone.

What size router bits does it accept?

It accepts compatible bits with a standard 7/8-inch bore and M10-1.5 bolt, including common 2 cm, 3 cm and 4 cm bits.

How much does the router weigh?

The router weighs 22 pounds.

What is the listed operating speed?

The listed no-load speed at the bit is 8,500 RPM.

Are the power cord and water hose included?

Yes. The supplied components include an inline GFCI with a 25-foot cord and watertight quick-disconnect, plus a 10-foot quick-disconnect water hose.

Are router bits included?

No. Router bits are not identified as included.

BB Industries carries professional stone fabrication tools, adhesives, polishing supplies, installation products, and equipment trusted by fabricators throughout North America.

BB Industries has you covered!