Hot Stuff Water-Clear Glue, 2 Oz. (HS-4)

Hot Stuff Water-Clear Glue is a super-fast cyanoacrylate adhesive used for retouching small scratches and repairing chips in most types of stone. The water-thin formula applies clear and dries completely clear, making it a fast and cost-effective solution for stone repair applications.

Hot Stuff can be used with a separate aerosol or pump accelerator to regulate setting speed. Although the adhesive will eventually cure without an accelerator, curing may take hours when it is left exposed on a surface. An accelerator allows the glue to cure within seconds so excess material can be trimmed immediately when needed.

Applications

• Retouching small scratches in most types of stone
• Repairing chips in stone surfaces
• Filling chips in granite countertops
• Bonding granite during countertop fabrication

Application Information

For scratch or chip repairs, apply the adhesive and allow it to cure. Lightly polish the repaired area with extra-fine steel wool or a buffing pad.

When filling a deep gap or countertop chip with NCF Stone Accelerator, apply the glue in layers approximately 1/16" thick. Allow each layer to harden before applying the next layer to prevent the surface from curing while the adhesive underneath remains soft.

Accelerator Information

• NCF Quick Accelerator (#16902): Provides faster curing but may discolor granite if over-applied.
• NCF Stone Accelerator (#16913): Cures significantly slower than NCF Quick Accelerator but is designed to avoid the discoloration that can occur when other accelerators are over-applied.

Specifications

• Product: Hot Stuff Water-Clear Glue
• Model: HS-4
• Size: 2 oz.
• Adhesive Type: Cyanoacrylate
• Viscosity: Water-thin
• Applied Color: Clear
• Dry Color: Clear
• Accelerator Required: No, but accelerator provides substantially faster curing

Hot Stuff Adhesive Viscosities

• Hot Stuff: Water-thin consistency
• Super T: Syrup-like consistency
• Special T: Low-flow, honey-like consistency

Please Note: Cure time without an accelerator depends on temperature, humidity, application and whether pressure is applied between bonded parts. When left on an exposed surface, the adhesive may require hours to cure.